thetyrant Posted October 8, 2019 Report Posted October 8, 2019 I have a G4+ Storm to go in my MR2 Spyder turbo build, im not quite ready to fit the turbo kit and ecu (which is hard wired into factory engine loom that came with kit off car kit was previously fitted onto) but i would like to pull the map off ecu now if possible to go over what has been done previously, is it as simple as connecting it to a 12v power supply and ground to enable me to do this ? Quote
cj Posted October 8, 2019 Report Posted October 8, 2019 Yes it is. Check the pinout in the help file then connect 12v, ground, and the programming cable and you are good to go Quote
thetyrant Posted October 8, 2019 Author Report Posted October 8, 2019 Thank you i will check that out tonight. Quote
Richard Hill Posted October 8, 2019 Report Posted October 8, 2019 Pin 5 on the a plug to 12 Volts, and pin 25 or 34 on the a plug to ground (only need one ground to bench power) HTH, Richard. Quote
thetyrant Posted October 8, 2019 Author Report Posted October 8, 2019 57 minutes ago, Richard Hill said: Pin 5 on the a plug to 12 Volts, and pin 25 or 34 on the a plug to ground (only need one ground to bench power) HTH, Richard. Thanks Richard that confirms what ive just been working out from the help file, always good to have it confirmed before plugging in! Ian Quote
thetyrant Posted October 8, 2019 Author Report Posted October 8, 2019 Got it powered up and pulled map off ecu, now time to see what we have in there! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.