G2 Link Queries

[Fredrik Pettersson]

Apparently the forums doesnt like IE9 or my computer, this was my post though :

So im nearing the stages to drop the engine in and all that.

Therefore im asking for a M54B30 base map, also i need to ask about the ignition;

Im using V.A.G 115F coils that have 4 leads , +12v,Engine GND,Trigger + and ECU Gnd.
My question is if i can run the ecu gnd to the link's sensor gnd ? Or should i just run it to the chassi gnd ?

Cheers // Fredrik

[Karim-Philip Antaki]

ECu ground to the batt - through the chassis if you wish.

Sensor ground: from sensors to the ecu terminals only.

 

Do not connect the together.

 

KPA

[Fredrik Pettersson]

Yes i know of those two , im asking if im to connect the pin on the Igniter which says 'ECU GND' to either the chassis or to the sensor gnd ?

Thanks for the reply

[Karim-Philip Antaki]

chassis ground. on the engine or frame.

 

cheers

[Fredrik Pettersson]

Thank you Karim !

As to a basemap , is there any avaliable for a BMW Inline 6 that i can use and then tune of ?

Thanks // Fredrik

[Karim-Philip Antaki]

I have something i can send you.

 

Send me and email and i will send it to you !

 

[email protected]

 

Cheers !

 

KPA

[cnycny]

Im also interested in a basemap for this engine =)