Crispin Posted August 18, 2008 Report Share Posted August 18, 2008 I've recently finished my wiring harness based on a Link unterminated 2 m loom. I got input on trigger 1 on the software while cranking but not in trigger 2. After a lot of testing it turned out that the knock 2 and trigger 2 input wires on the connector were switched. Could you please confirm that this pinout diagram is correct? http://www.linkecu.com/support/dlandswupdates/TechInfo/WiringAndInstallation/G06 Quote Link to comment Share on other sites More sharing options...
Johann Posted August 19, 2008 Report Share Posted August 19, 2008 It is a known issue. http://www.linkecu.com/forum/forums/lem/365743043 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.