Jump to content

Clutch Switch Installation for Launch Control


Weldon
 Share

Recommended Posts

Hey guys,

         So i have a Ver 5 STi RA with a G4 PnP installed. I am trying to set up my Launch Control, but since the 1st Gen Imprezas dont have a Clutch Switch, the Launch Control Feature will not work. I went and bought a switch, now i just need help with wiring it into the box, and then setting up Launch Control. Any Help would be very much appreciated!

 

                 Thank You,

                                     Weldon

Link to comment
Share on other sites

Hi Weldon,

is your switch a momentary switch, only active when depressed,

 If so then your away, just wire one side of the switch  to a spare digital input and the other contact of the switch to ground.

You need to then setup the digital input as Launch Control and set the active edge to falling and pull-up resistor to ON.

regards

Dave.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...