G4 wire on M42 e30 318IS

[mikarr]

hello!!!

I'm going to buy a block G4 storm for the BMW e30 engine M42.

What accessories can I need? the car will be equipped with a turbine, and so I will need a MAP sensor and the IAT sensor. Can I install the 2.5 bar MAP sensor from G3 to G4 Storm?

Most of all I am interested in any other suitable sensors for use with  G4?

I have the following items on the company's sensors, Bosch and original products.

ECT   13 62 1 709 966 OEM    0 280 1300 26 Bosch

CRANC sensor 12 14 1 721 968 OEM 0 261 210 057 Bosch

CAM sensor 12 14 1 721 861 OEM 0 261 210 058 Bosch

 TPS 13 63 1 726 591 OEM 6PX008476-111 HELLA

Can I use to block G4? If not, what sensors you recommend instead? 

thanks in advance for your reply!

[Guest Dave]

what do you mean    'Can I use to block G4?'      

those sensors will work fine as long as they are wired and configured correctly

yes the 2.5 map sensor is the same that was used withe the G3 ecus       personally a Link plus G3 or ideally a G4 Extreme would work better in your application 

Regards

David Heerdegen

[email protected]

 

[mikarr]

Sorry for bad english  

Thank you for your advice! 

The control unit G3 is available for sale? I just thought that it no longer 

produce

Do you recommend them because of the greater number of temperature compensation, or have other reasons?

 

[Guest Dave]

sorry the way i read your first post it sounded like you had a G3  

the G3 ecus are no longer available so best to use a G4 Extreme   No other reasons just a G3 link plus (if you had one) or a G4 Extreme is better suited to your project  over a G4 Storm   the Extreme will allow you to run sequential fuel and ignition   ( i am presumimg it is a six cylinder)

Regards

David Heerdegen

[email protected]