Analog in as gear cut control channel

[HÃ¥kan Foldefors]

For clutchless gear cut you would use a load cell on the gear stick that has a 0-5v output. So it would make the install alot simpler without external electronics if you could use analog in with a trig voltage as gear cut control channel.

http://www.srpcontrol.com/product-p/ka-gst.htm

[Dave Kriedeman]

Hi,

Do you have a spare digital input available.

If so set that digital input function up as GEAR CUT.

Pull up resistor OFF

On Level =  High

Active Edge  = Rising.

Go down to MOTORSPORTS TAB and open the GEAR CUT CONTROL TAB.

The rest of your setup is done here and the GEAR CUT EDIT TABLE.

Regards

Dave.