Guest |99| Posted June 2, 2009 Report Share Posted June 2, 2009 Is there a way to activate an additional boost table for a pre-set time using a momentary contact switch as a DI. I have looked at using the input switch to trigger an output however the GP outputs seem to have an upper limit of 5 seconds (fuel pump, GP output condition No.3 off time). I could cascade a number of GP outputs to get higher on times but this would be messy. Quote Link to comment Share on other sites More sharing options...
rayhall Posted June 2, 2009 Report Share Posted June 2, 2009 Chris, What time range do you require. Quote Link to comment Share on other sites More sharing options...
Guest |99| Posted June 3, 2009 Report Share Posted June 3, 2009 Hi Ray, I will need about 12 seconds which is the length of a straight. Thanks Quote Link to comment Share on other sites More sharing options...
Guest |99| Posted June 3, 2009 Report Share Posted June 3, 2009 I've made an IC 555 timer that I can trigger from the MOM switch and use the output from this to hold a DI high for the required time. However, it would still be better to do it from within the V88. Quote Link to comment Share on other sites More sharing options...
rayhall Posted June 4, 2009 Report Share Posted June 4, 2009 Timers are going to be added. I was going to suggest using an external timer. Ray. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.