efi265 Posted October 24, 2015 Report Share Posted October 24, 2015 have been tuning is running e85 at the moment but has some lean spots around 3-4000rpm upto 22afr under deceleration and the fuel map graph is ugly what do you think cheers e85.pcl Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted October 24, 2015 Report Share Posted October 24, 2015 Hi efi265,I haven't had a look at your pcl file as yet.Just a quick question , do you have decal/overrun fuel cut active.RegardsDave. Quote Link to comment Share on other sites More sharing options...
efi265 Posted October 26, 2015 Author Report Share Posted October 26, 2015 its set to off thanks Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted October 26, 2015 Report Share Posted October 26, 2015 Hi efi265,sorry for the short abrupt answer, I am unwell and head for surgery tomorrow.I will have a look at your PCL file today and see what I can spot.What brand of wideband are you using.Also it is not uncommon to read lean or very lean mixtures on overrun as these areas are not tuned very often.Areas of high vacuum I find a good down hill run and tune these spots on decal.Often these areas are way to rich and the wideband will read lean as there is a lot of unburnt air in the exhaust..But to be sure I will check your pcl.RegardsDave. Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted October 26, 2015 Report Share Posted October 26, 2015 Hi efi265,I have made some changes to your file.I have tidied up you ignition main table, employed idle ignition timing control.Disabled CCL , which you had active, this should only be activated and setup once the engine is tuned completely and properly.I removed the 38% fuel main trim and applied it to the main table as a 30% overall trim.This pcl file is designed as a starting point for you for a much tidier and accurate tune.Let me know what issues you have.If you are using MIXTURE table to tune the fuel main table , please setup the filters as to deactivate recording transitional changes such as closing TPS, MAP values changes etc etc.This will lead to bad fuel tables, not sure if you where or not, but just a side note for you.RegardsDave. EFI265 E85_DAVE_TOUCH UP.pcl EFI265 E85_DAVE_TOUCH UP.pcl Quote Link to comment Share on other sites More sharing options...
efi265 Posted October 29, 2015 Author Report Share Posted October 29, 2015 thank you will see how we go awsome thanks i am running a lc2 innovate wideband and am going to re-calibrate it if you can hope all goes well for you and thank you for your time cheers Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.