Guest |150| Posted June 10, 2009 Report Share Posted June 10, 2009 Hi, I want to use my oem map sensor for crank case pressure monitoring, could i get the numbers for the calibration from you? it's the same sensor that is in the software but i can't select it for anything other than the map application. regards Marius Quote Link to comment Share on other sites More sharing options...
rayhall Posted June 10, 2009 Report Share Posted June 10, 2009 Marius It will take me a few days to get you the information. Quote Link to comment Share on other sites More sharing options...
Guest |150| Posted June 10, 2009 Report Share Posted June 10, 2009 ok, thanks Quote Link to comment Share on other sites More sharing options...
Guest |150| Posted July 5, 2009 Report Share Posted July 5, 2009 have you had a chance to find the parameters? Quote Link to comment Share on other sites More sharing options...
rayhall Posted July 6, 2009 Report Share Posted July 6, 2009 Sorry I forgot. The information is hard coded into the firmware, so someone has to look though the code to find it. Should have an answer in a few days. Ray. Quote Link to comment Share on other sites More sharing options...
rayhall Posted July 14, 2009 Report Share Posted July 14, 2009 Here is the information. Input A = 0.5 V Output A = 13.5 kPa Input B = 4.5 V Output B = 161.7 kPa The sensor will measure to 9PSI boost (161 kPa) Quote Link to comment Share on other sites More sharing options...
Guest |150| Posted July 16, 2009 Report Share Posted July 16, 2009 thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.