Guest |603| Posted May 21, 2010 Report Share Posted May 21, 2010 Hi, I just got installed my vipec, It´s EVO 6,5 PnP with firmware 4.4.3 I have 2 fault codes that comes on after engine have been running about 5 min. Faults: AN3 and AN4 volt above when checked from fault list says AN3 and AN4 volt at ground. but values are OK. AN3 is used for TPS main. AN4 is for WB sensor Any ideas? Quote Link to comment Share on other sites More sharing options...
rayhall Posted May 21, 2010 Report Share Posted May 21, 2010 Read the sticky post on Firmware 4.4.1 or later. This explains the error codes and how to clear the error history. Ray. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.