Guest |166| Posted June 30, 2010 Report Share Posted June 30, 2010 well i updated my ViPEC software to 4.51 and my Speed no longer works. it is set to DI#4 Pullup Resistor = ON Active Edge = Rising Calibration DI#4 = 260 i know the ECU is getting input because when i set a digital gauge to show Frequency (Hz) it works. the frequency goes up with the vehicle speed. but the speed just shows OFF. can i turn it on, when did i turn it off? P.S. Gear detection still works. so again i know that the ECU is getting the signal? any help is awesome (i am hopeing i just cant find a setting in the new softwear) Quote Link to comment Share on other sites More sharing options...
rayhall Posted June 30, 2010 Report Share Posted June 30, 2010 When you press the R key and then select the Digital tab, is the speed shown in kph ? Ray. Quote Link to comment Share on other sites More sharing options...
Guest |166| Posted July 1, 2010 Report Share Posted July 1, 2010 well here is a screen shot. looks like the Digital Data is good. Digital Input still says "OFF". with the speed signal OFF the launch control will not work. sorry about the large image, but you couldnt see it when i shrunk it down. Quote Link to comment Share on other sites More sharing options...
Guest Hic Posted July 1, 2010 Report Share Posted July 1, 2010 Suberdave everything is ok. You have a speed of 25kph on your D4 input. It reads OFF but in reality it tells the speed to your ECU. Send me the map and I will look at it, as I just mastered the launch control :D:D (with minor help from Ray ) Mail is [email protected] Quote Link to comment Share on other sites More sharing options...
Guest |166| Posted July 13, 2010 Report Share Posted July 13, 2010 well i guess i was just displaying the wrong data... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.