madenis Posted November 25, 2019 Report Share Posted November 25, 2019 Hello i work on crosstreck fb20 I need help to make a trigger patern for a crostreck 2017 hall effect sensor 16 tooth / 4missing /1 tooth / 4missing/13 tooth /4missing and cam 3 tooth went missing tooth on crank i made a scope of crank and cam need a help in link nothing works for this trigger Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 25, 2019 Report Share Posted November 25, 2019 The pattern matches the EJ20 Quad AVCS trigger mode, but there appears to be something wrong with your crank sensor - either it is not a hall sensor, it is wired wrong or doesnt have a pull-up enabled when you done the scope or something. If it is a hall sensor you would expect to see wider "square" teeth, not sharp spikes like your scope shows. Also many of your "crank teeth" only go down to about 2V, they need to go below 1V at least. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.