esso Posted April 4, 2020 Report Share Posted April 4, 2020 hello, i have a link pnp for evo 7 and i bought the expansion harness to use the extra AN6,7,9,10. but when i try to use them they dont response to any signal. i tried to check them on board direct they dont respond they always stuck on 5V Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 4, 2020 Report Share Posted April 4, 2020 Sounds like you probably have the error settings wrong. Set the AN Volt function to 0-5V and set error low to 0.0 and error high to 5.0v. Then test by connecting the AN Volt to the ground wire and the 5V wire (also on exp loom). Quote Link to comment Share on other sites More sharing options...
esso Posted April 5, 2020 Author Report Share Posted April 5, 2020 i already did what all you mentioned and it stuck reading error and 5V Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 6, 2020 Report Share Posted April 6, 2020 If its still reporting an error then you have the error settings wrong. The error settings I suggested above will completely disable the error/fault functionality. Can you attach your tune. Quote Link to comment Share on other sites More sharing options...
motomattx Posted April 6, 2020 Report Share Posted April 6, 2020 Maybe it has to do with having your pull up or pull down settings in your inputs? Quote Link to comment Share on other sites More sharing options...
esso Posted April 14, 2020 Author Report Share Posted April 14, 2020 it end it up to be bug in the basemap supported by the linkecu. i burn the latest basemap and it worked like charm Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.