2 wire iscv

[jonnyt80]

I have a 2 wire idle control valve which im trying to setup.

Any pointers as when i go into the settings ats asking for 4 pin or 6 pin only.

Cant get it to idle without adjusting the throttlebody

[Simon]

Hi Jonny

When running a 2 wire unit the 4 and 6 terminal settings are ignored. Just make sure you have ISC solenoid select on the Aux output and not stepper.

You want the engine to be able to hold a low idle with no idle control before setting up the idle.

Start with open loop first and get that as close as possible before switching to closed loop. 

[jonnyt80]

Do i still alter the settings in the idle setup apart from 4/6 pin or is it the frequency I need to play with in the aux menu.

The car holds idle without idle control on. I had to adjust the butterfly to allow more air in and play with the ign timing but now holds around 850-900. But would like the solenoid operating

Thanks

[Simon]

The figures will all be in duty cycle and will function as such.

Have a look at say the Nissan base maps these are set up to be a solenoid controlled idle.

 

[jonnyt80]

Thanks simon