Only 2 wires for can tho?
Iv tried swapping them around can H and Can L and even moved them to Can 2 but same story
Any idea what I could have done wrong?
good day trying to confirgue a link thunder ecu to a motec SDL via can H and can L
I Have tried all wire configirations with and without 120ohm resisters but cant seem to connect the two
iv attached my base map and dash config file
please help
base map bat.pclr
SDL-Dash-Link(1).U16
HI adam
iv done all the changes you have advised
we get spark just once when we start cranking then its gone
here in current file, triggerscope, cranking log
thanks
crank.llg
Trigger Scope Log 2023-04-28 9;16;28 am.llg
base map 11.pclr
hello
have recently wired a Link Thunder G4+ into a offroad buggy using a LS2/L98
we have RPM when cranking but no spark
on ignition test spark is fine
attached is trigger scope and current tune
please help
Basemap.pclr
Trigger Scope Log 2023-04-25 1;03;17 pm.llg