alexjohn
-
Posts
38 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by alexjohn
-
-
Ok adam
-
Ecu is running in boot mode and cannot connet...need help?
-
tq adam
-
2jzgte link strom idle to low use 2wire isc..startup to low.need help about setup
-
On 8/24/2019 at 5:35 AM, Benginetuner said:
Yes. The rx8 trigger wheel and sensors are on the jz engine along with coolant temp and oil pressure.
hi benginetuner
how u do the engine light and alternater light at rx8 dash work? the wiring to connet please?
-
HI ADAM
ask some question about the alternater wiring ?the d1 wiring to alternater light is right?
-
canbus file for rx8 runing gauge oem....use engine 1jz ecu strom ?
-
On 1/9/2019 at 7:23 AM, Adamw said:
yes, this will receive wheel speeds via CAN. The termination resistor can only be removed (unsoldered) but try it as it is at present, I have had systems work fine with 3 resistors connected before.
also attached an updated map that has a bit more CAN bus dash functionality set up.
the canbus file for can bus rx8 1jzvvti ? ecu link strom
-
isues timing for nissan 15 degree offset -98 at pully mark 15 at three line is correct or wrong lock timing?
-
Oli pressure so low aready test
-
Aux 1 test pwm solenoid have Clicking...i test on the solenoid open little
-
i try run the engine have the load... the vvti counter error....
-
fisrt start run vvti have sound is error ....second start is normal back no error
-
already set vvti mode 1jz ,cam angle off,trig 2 vvti off 174 still error counter
-
vvti solenoid is connet cam control 1jz on .cam type off. no error
-
cam control mode off and cam type.... is normal no error vvti
-
-
-
-
-
Test pulsecount 2 off still errors counter ...what have to check please?
-
Confuse vvti setup?
-
-
K20 cool dewll
in G4+
Posted
Need help 1jzgte use coil k20 setup dwell time?