gtihk
-
Posts
53 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by gtihk
-
-
I have an answer from Adam.
For the benefit of others who may want to know. A1 can have flow of up to 10A and A5 is relatively low current of not more than 3A.
-
Try increasing Idle aim and also adjust normal position of the ISV.
Different cams may require some more air to idle.
Also look at ignition timing. May need more too.
-
Anyone?
-
According to memory, a DI input can be configured as anti-theft.
We also in the past fitted a hidden switch to interfere with trigger inputs, not necessarily to disconnect it.
-
I think you mainly use Factory wiring with the single knock wire to the Bosch which other side should be wired to any sensor ground.
-
May I know the Maximum current draw on Pins A1 and A5 on the Link Force GDI ECU please?
-
Texense
-
I have a question regarding closed loop fuel.
In the log attached, at around 6000 rpm, Lambda aim is 0.88, Lambda 1 is 0.992, yet the ECU is pullinCIVIC RUN1.llgg 12% fuel. Why does it do that?
-
Anyone please confirm where CAN 1 is connected please? I can see CAN 2 on connector B.
Could CAN 1 be on the Port below the USB tuning port?
-
CAN Lambda
in G4+
I used the same sensor with a conventional Lambda controller. The sensor seems OK.
-
CAN Lambda
in G4+
Sensor was brand new from the box. Not dropped once.
Resister in place.
-
Let me know if I can be of help when you have the hardware arrived.
-
CAN Lambda
in G4+
I am trying to install CAN Lambda to a Civic EG with plugin ECU.
I followed the instructions and added a dedicated relay with the correct gauge wire.
I am seeing errors 16, 33 and 34.
I even added a 35v 22 uF capacitor as suggested. Still no luck.
Anyone?
-
I had some problems initially but Michael at Virtualhere was very helpful.
He used Teamviewer to help me. Considering that I did not pay for the software, it was wonderful service.
-
-
I WOULD START WITH ABOUT 16.
-
Thanks, it is working now with firewall turned off. I did not personally turned it on, but I guess it is a default to be On.
-
I have the Mini Router now and updated its firmware as advised.
I can connect to the CloudhubXXXXXX, but cannot see ECU.
Any ideas please?
-
This is 12v in and 5v out. It does not sound right.
The WiFi device should need 12v, right?
-
Where can I get one please?
-
What is a 12V micro USB adapter? Is it where the power for this WiFi Router is coming from?
This looks nice but quite expensive.
-
Great info!
-
I do not know what ECU you are using.
You can use the plug in base map as a start file but make sure that your inputs and outputs are matching.
In particular, you need to look at MAP sensor allocation and calibration as the plug in uses an internal MAP sensor.
-
you need to tell the ECU what sensor you have in order to have a correct temperature.
As for the fan, I think you could test is by assigning it as a GP output and then use the test output function.
Ej20g Side feed injectors
in G4+
Posted
Look at Deatschwerks. They have a good range but according to experience, their deadtimes are not usually spot on.