Knox

I'm the tuner, I tuned everywhere below 0.9 bar and all is good with part throttle and below 0.9bar. Thank you for reply. I will check rrob's adivse to see if its the issue. Might be injector settings but it should be correct at base map. I checked it now. "Speed Control Method" is off. may be this is the issue. What it should be? Can you help me please.

Hello, Today I installed Link G4+ plug in ecu to evo 8. With stock evo 8 ecu air fuel ratio is 12-12.5 at 1.3 bar boost but on Link ecu at 0.9 bar after 5500 rpm air fuel ratio goes to lean 13.5-14. Of course I try to adjust it by increase injestor duty cycle but no result engine runs lean again. I also canceled the fuel pressure solenoid and result is same. So with stock ecu 1.3 bar afr is ok but on Link ecu 0.9 bar after 5500 rpm engine goes lean. What it can be the reason, what should I check ? Thank you.

Hello Adamw, when I change Ignition Drive 4 to low fan switched off. What should I check ?

Hello, I'm newbie in Link world. I bought a g4+ plug in for my evo6. I tuned the car but I couldn't control the engine fan. Engine fan works all the time. Can you advise me what should I do, I think its about wirings ?

Thank you Adamw. Can I ask more later when I try to install sensors.

Can I ask how can I install crank position sensor and remove distributor completely? Can I ask how can I install crank position sensor and remove distributor completely?

Thank you. So, Spark edge should be "Falling" and Dwell mode should be "ms"? Please confirm for me. And I'will be happy if you help me for dwell time adjustment.

Hi, thank you for reply. I found analog outputs after I saw you reply. I'm trying to have a starting map, I changed analog outputs and Ignition Output to "Direct Spark". Is spark edge should be "Falling" ? Is Dwell mode should be "Duty Cycle"?

Hello, I'm a tuner and I tuned some link ecu before but all are plug in or already wired from someone. I'm going to tune my firends civic eg with big turbo setup, I advised him to use Link ecu (he has hondata) because of antilag and also I want to cancel oem distributor. Can I wire honda k20 coil to Link plug in ecu or I buy for him a universal Link ecu and custom wire all sensors ? I tuned to many turbo civic on hondata but I'm new at Link and also I don't have too much experience on wirings.