[trigger 2 sync problem]

I put the parameters you advised and it's work pretty well. I test approximately 10 cranking and it starts directly every time. 

Thanks @Adamw @Simon

[trigger 2 sync problem]

after reversed polarity of trigger1 (capture attached ) , en set tigger2 sync to 'cam level' , engine run like before. sync still does not work.

for VVT , i configured tooth off set with cam angle test and now work good.

sync mode can work only when you have only one tooth may be ?

you can confirme sync  it's 'ECCS sync' on runtime value?

 

[trigger 2 sync problem]

Ok, thanks i will try reverse polarity and test on cam level mode. 

[trigger 2 sync problem]

Hi,

i have a problem for make sync with trigger2 wheel on cam. That result to not start directely on first cranking but on second it's run.

this a inlet cam on VVT , 3 tooth with different off set ( i can not ajust too ), can a use them for make a sync and vvt position ? i'm totaly loss 

spec : ECU Xtreme G4+

Engine : peugeot 260 rc , EW10j4S , mount on sequential direct spark.

trigger scope attached

thanks for help.

 

 

206alex.pclr