[Aux output always sent out 12v+]

Thanks Simon, I got it.

[Aux output always sent out 12v+]

Hi Simon

Thanks and I got it.

As you said Aux 4 in my SW should set OFF and I can't use it, is it right?

 

Also, Could you please help me to check what is the function of the pin 11 and Pin 46 in my Ver.1.5?

Thank you.

[Aux output always sent out 12v+]

Hi Adamw

Thanks for your info.

As your picture shows the pin at expansion connector 1 is "DI10" not "Aux4"

I thought the DI 10 is at pin 46 ( infomation from the wrong version manual), so where is my Aux4 pin?

Could your please provide me the correct manual incl. pin-out information? I think I should check all my wiring and setting.

BTW, there is "PCB V1.4" painted on my PCB, but there also has a white sticker show "PCB REV 1.5" and my serial number.
May I confirm that my ECU version is V1.5 right?

Thanks.

[Aux output always sent out 12v+]

Hi Adamw

There is "PCB V1.4" printed on my PCB, but "PCB Rev 1.5" printed on my Link G4+ packing Box cover.

I set Aux 9-16 to OFF, Aux 5-8 to ISC Stepper.

Thanks for your help.

 

[Aux output always sent out 12v+]

Hi, I can use another channel (IGN or Fuel) but If Aux4 in expansion connector  can't use, what the real pin out define this pin is? (expansion connector Aux4)

[Aux output always sent out 12v+]

Hello

I saw Aux4 in expansion connector 1 from manual (as picture attached).

I  cut the power 12v+ (relay pin85) and measure the voltage between "Aux 4" pin (from expansion connector1) and chasis ground, the meter shows 10v no matter Aux4 is OFF or ON (stasis shows in PCLink)

Could you please help me to make sure the Aux 4 in manual is correct or not?

Thanks

[Aux output always sent out 12v+]

My ECU is EVO4-8 plug in and my aux4 is only low polarity can choose.

I will try cut the relay 12v+(pin85) and measure the pin 86 only later.

 

Thanks.

[Aux output always sent out 12v+]

Hi guys, I set my Aux out 4 to GP out to be my shift light trigger.
My wiring setting as attached picture, 
I use a 5P relay and it should active when link G4+ send GND signal.

But Aux out wire always send 12v+ high voltage even the trigger condition is achieving.

I also try set Aux out to Test ON, and it still always sent 12v+

Does any one can help me to slove this issue?

Thanks for your help. 

[ABS check light ON after share wheel signal]

Thanks Simon.

I will try it and hope everything goes well.

[ABS check light ON after share wheel signal]

Hi 

There are 2 wires come from my ABS sensor (GND and Signal)，I want to share the wheel signal to my Link G4+ Digital input but after I share ABS signal to Link G4+ the ABS check light is ON.

I set the pull-up resistor ON in the Wheel speed function but nothing help.

Does  anyone can help me to solve ABS check light problem?

Thanks.