Poseidon

if i have mini it works, which one of them doesn't

doesn't Work

Is there a list of what lies behind the can bus mini r50-r53 need the data for wheel speed. Data: Receive user, ID496, Format: Normal or? Stream Frame: Start pos, width, byte order, type .... from LF / RF / LR / RR Wheel Speed I currently have start pos LF = 0, RF = 16, LR = 32, RR = 48 and width 12, LS First ... no function

thank you now i am facing the next problem, with inlet and outlet target table there is 0 in it. who has a clue which values I need or how to test the values aux for the valves are now active, think it works

Can someone help me with this problem with the vanos setting. outlet believe could work because I get no errors. inlet has signal errors. also do not know if the offset fits engine is bmw m54b30 biturbo

help please

Vehicle speed controller runs via can bus. have the multifunction steering wheel how do I set that at xtreme

have a vacuum pump with this it goes to the vacuum accumulator and then via the MAC valve to the vacuum box when the mac opens, the pressure is no longer reduced. therefore the table must be different or?

I converted my boost pressure control to negative pressure. Have a MAC 35A-AAA-DDBA-1BA valve. how do I set up the table to run close loop boost. The control unit is xtreme

installed an m54b30 engine, not the s54b32 don't understand how to set it up

have the ignition table already sharper idle close loop anyway when maneuvering it sometimes dies idle ignition table warm 14 degrees -100 rpm 18 degrees +100 rpm 9 degrees

Works great how can I now use the steering as a digital input that is taken into account at idle speed? i need that for traction control

Help

I did that too but instead of ect I took oil which makes more sense. unfortunately DSC and steering angle does not work

who can help me, am desperate. steering I have a signal, but the wrong one. there is also something wrong with the wheel speed

have a bi turbo and have two wastegates. Motor 1 and motor 2 would then be wastegate 1 and wastegate 2. On S4 and S5 to xtreme output 1 and output 2 the giver from the wastegate in a table what controls the outputs of the xtreme

got this wastegate on the turbo from bmw n55b30 how can I control it with the xtreme g4 +

Trigger -324 Ignition coils vw audi NGK 48041

Nobody can help me

Everything works except for the DSC. (MK60) DSC would be very important that it works. Can anyone help me with that Still have the problem that he almost dying while steering in the stand. Idle ignition I have stepped in 3 degrees

can anyone help me with this injector? Need the deadtime for my link g4 + Xtreme

works very well Only the oil level is not correct, the only looks through timer. I still need steering. When steering in idle the speed goes down sharply. Where I leave it idle I know. but he does not recognize the signal from the steering

Thank you very much The oil temperature, speed and water temperature work. engine control light does not work as well as water temperature light oil level? switching lightning does not work yet. Picture attached

Hello everybody Have a BMW e46 330ci with M3 instrument cluster. ECU is an Xtreme. I've set the can mode mini r50-r53. some works well. Unfortunately, the oil temperature in the M3 tacho not. but that would be very important for a turbo engine. synonymous, the dsc mk60 does not work what I would be important. In addition, it shows the steering position of the runtime misc. Unfortunately, the engine almost dies from me when I steer the stand. Is it possible to integrate the steering during idling without input directly? can someone please help me my English is not good. Take the translator thank you