Septy

I did not turn off ,I will try Thanks

Hi Adam! so what can be the problem with the can board ?

Yes

I made the pictures before I installed the board on the car. Yes I set the board to 1Mbps.

This is the board , on the CAN communication seems to be ok ,I Don't have the ecumaster USB to CAN interface to setup the boar with the Light Client , I close the speed jumper on the board to have 1Mbps speed its all I can do.

Hello I install a ECUMaster CAN switchboard V3 and I wired up 2 Bosch PST-F1 sensors to the board ,I put the sensors before and after the Intercooler ,but the signal is very noisy. Can anyone help me ? Thanks! Subaru Forester 2.0 XT AVCS ADS 2022 PCLink.V6.21.21.Ianuarie .15. Ethanol MAP V.8.pclx PC Datalog - 2022-02-4 8;09;27 pm.llgx Intercooler Sensors Test 2.llgx

Hello I setup my gear shift control on my sequential gearbox but I don't know how to make the E-Throttle to blip , If I try to setup the Blip Solenoid I receive this.... Can anyone help me ? Thanks!

Hello Recently I changed my stock STI gearbox with a sequential gear box from XShift gearbox , I wired up my strain gauge but when I pull the lever backwards to change from the first to second the voltage its drops instead to raise up and the Gear Shift Status shows down shift instead of upshift can anyone make me suggestion why this can happen ? I put a copy of my map and the wiring loom diagram. Gear lever Subaru +Plus The lever works with 5V. In the middle position is 2.5 V. If you push the lever forward, the Voltage drops to 0V and if you pull the lever backwards, the Voltage raises to 5V. The lever is adjusted to 80N. The number and position of the wires (3, 2, 1) you can see on the top opposite connector. 3 _0-5V (output), …2_0V (ground), …1_ 12V (input). Thanks wiring-loom-usable-with-ecu-capable-of-ignition-cut.pdf Subaru Forester 2.0 XT AVCS ADS 2021 PCLink.V6.20.67. Iulie Ethanol MAP.pclx

Hi Adam can you give me this link ? because every time when I start the engine the PClink it's locking up. Thanks

Hi! Finally the engine started ,I let the engine run 5 min after I turned it off. After an hour I wanted to start it again but when I put the key in on position it made a big and very loud back fire in the intake 2. My Link can Lambda does not display anything! some suggestions ?

Thanks Adam

Hello guys today I tried to start the engine ,but it did not wanted to start under no circumstances when I cranks it has a small tendancy to start. Can somebody watch on my map ,Loggs and a copy of Trigger Scope probably something I missed or I did wrong. Thanks Subaru Forester2.0 XT AVCS ADS 2020 Test Sensors PCLink.V.6.18.44.pclx PC Datalog - 2020-11-16 6;54;02 pm.llgx PC Datalog - 2020-11-16 6;58;22 pm.llgx TriggerScopeLog.llgx 16.11.2020 18.56.llgx

Hello guys I Wired up the fuel pressure sensor on An Volt 7 pin D24 ,and the sensor is not working. I checked the wire , I changed the sensor but it's still not working. After this I changed from An Volt 7 to An Volt 4 and the sensor its working. what could be the problem with the An Volt 7 pin D24? Two weeks ago the pin was working

Thank you Adamw