Bethanyc

Thanks Adam, must be a bad ECU plug pin wire not making connection, its not seeing any voltage with the switch off. Ill swap it out , else try one of the other spare DI inputs.

Hi link team, is there anything special on the DI10 interface on the G4X Evo 4-8 PNP board (ECU plug pin #46) i cant seem to get a simple switch setup on this interface, it should be straight forward, i have grounded one side of switch, and confirmed it is working at the ECU plug. I know this DI was originally assigned clutch switch, which is disabled in the config. (which my Evo also does not have) i might try move the cable to DI 5, 6 ECU pin in the morning, as these are also not in use on my Evo.

Thanks Adam, in that case it will make the install very easy

Sorry yes the plug in G4X Evo IV-VIII ECU

Hi Link team, just about to do an install of G4X and MXS 1.2 in an Evo 6 rally car, Can the CAN 2 + output be used to power the display ? or is it not advisable. Was only to make the wiring install very neat. Nothing else will be connected to the display. Thanks Beth.