Vitalka

Hey, just wanted to update this. I had to send the gauge back to them and got it back few days later. Looks like my gauge had a faulty board which was replaced. Connected it to the ECU, set it up and everything is working great. Thank you for the help

Hello. After not being able to get the GaugeArt gauge to work with my G4+ and not getting much support from them, I want to try DashBoard. Will it display AFR from Link CanLambda? Also will it display boost from Link internal MAP sensor, or do I need external MAP sensor?

You're right, I did unplug the TPS a few times to adjust the throttle cable. Do you know if G4+ has 120 ohm resistor? The gauge does

Also, when connected to PC Link I get error code 14

One thing I forgot to mention is GaugeArt requires a 120 ohm resistor https://gaugeart.com/instructions/gaugeart-can-gauge/terminating-resistor-configuration/ which I don't have. Could that be the issue?

I followed instructions from their website on how to enable ECU telemetry. I assume it came pre-programmed from them, but will get in touch with them today and update. Thanks for your help

Thanks for moving the thread to the correct forum. Can you take a look at the connectors? 5 wire connector is for Can Lambda and connected to Can 2 OBD. Two wire connector is for the gauge, the harness came from GaugeArt. It's connected to Can/RS232. Do you see anything wrong with the wiring?

Thanks for your reply. Here's the tune Eshift base tune.pclr

Hello, first time poster. Currently running BMWLink E36X ECU in my swapped turbo E30. Got my GaugeArt CAN gauge today and plugged it in. Link Can Lambda is connected to CAN 2 OBD on the ECU and shows up CAN Devices. Gauge is connected to CAN/RS232 on the ECU. I enabled ECU Telemetry as per GaugeArt's instructions and set it up to show AFR, IAT, Oil Pressure and Boost. For some reason, the gauge is non reactive and not showing up in CAN devices. What am I missing?