[Wiring diagram for Civic Link G4 +.]

Hello.
I have a 1996-99 HC96 CivicLink installed.
Everything is fine, it starts fine and everything works perfectly, but the fan does not work.
Is it possible that the fan pin needs to be modified?
Greetings.

[Wiring diagram for Civic Link G4 +.]

Ok, thank you very much for the clarification.
Greetings.

[Wiring diagram for Civic Link G4 +.]

Hello, it's the PCB REV 1.2.

[Wiring diagram for Civic Link G4 +.]

Hola, tengo un Civilink G4 + HC96 +.
En el manual de descarga en el sitio web del enlace hay dos conectores de expansión y en mi ecu solo tiene uno.
¿Es posible que esté utilizando un diagrama de cableado diferente?

Saludos.

[PDM for G4 Xtreme.]

Hello.
For my G4X Xtreme link, which PDM advise me, I don't know anything about the CAN protocol, and I don't want to buy something that is impossible to program for me.
Greetings.

[XAP G-DASH]

Thank you.

[XAP G-DASH]

Hello.
I have an xap display, G-DASH model.
I would like to know if it is compatible with the link G4X models.
Thanks.

[Xtreme and sequential gearbox.]

I have received the new connection cable from NZEFI and it works fine.

 

[Xtreme and sequential gearbox.]

I have contacted NZEFI and they sent me another replacement cable at cost 0.
Serious company for me.

[Line can, Link Extreme and MXG Strada]

Thanks for the help Adam, everything works fine.
Greetings.

 

[Xtreme and sequential gearbox.]

I bought my cable at NZEFI.com, I have installed it on my board and it does not work, it does not connect to the ecu.

[Line can, Link Extreme and MXG Strada]

thanks for the reply Adam.
in pc link I don't have to confugure anything?
my configuration is as follows.

 

[Line can, Link Extreme and MXG Strada]

Hello, I have my Xtreme X ECU connected to an MXG Strada display by Can line and everything works perfectly.
How can I add a new line?
I want to show on the display when the launch control is connected.

[Xtreme conection PC.]

Hello everyone and thanks for the answers.
I have already solved.
If it had 12v on pin 5.
The car started perfectly and everything worked, the only problem was the fuel pump always connected and it did not connect me to the PC.
I had to update the ECU to get it connected again, and it was not easy to do so as it did not connect to the PC.

[Xtreme conection PC.]

Good morning.
My ecu Xtreme X was working perfectly.
He loaded the map and everything is perfect, the signal works smoothly with the display, everything is perfect.
I have started it again but the fuel pump does not stop always connected and the PC does not connect to the ECU.
What is possible that is happening?

[Xtreme and sequential gearbox.]

Thanks for your answer.

Regards.

[Xtreme and sequential gearbox.]

Ok Adamw.
Thanks for your answer, I have solved the question.

Another question:
Is there a "CUSB" cable with the MXG display terminal?

These extremes.

 

[Xtreme and sequential gearbox.]

Hi.
I'm new in the forum.
I wanted to know how to set a potentiometer for my sequential gearbox.
How to configure the gearbox?
What analog to use?