Mr_Flibble

Although this log is a little better, I was adjusting the fuel up as it felt like it died because it was fuel starved.

It's a link g4+ hc92+ It has not yet been tuned, I just need to get it to run long enough to get the vehicle to the garage. soller.pclr

I managed to sort the timing out (problem with the hardware in the end) But now the engine just seems to run then when (I think) it gets to temp the engine just dies like it ran out of fuel. The second issue is my old CPU used to send some sort of signal to the boot/roof ecu and the link 4 doesn't seem to so the roof no longer retracts and I have a constant warning light on my dash.

I'll give it a shot.

440cc now

Sorry the laptop I was using decided to update. Log 2020-12-20 2;54;14 pm.llg solllu.pclr

It's a new install and I got annoyed and reverted everything and it runs (started to think it was a mechanical issue) so technically everything looks good. Is there someone I can just pay to fix it all?

Well, I have replaced the injectors and I checked the timing and set it, managed to get the engine to run for a short time. When I opened the throttle a little it died. Checked the timing again and it seems to of gone way off and I can't start it again. Something just seems wrong.

They are currently stock which means about 240cc and why I have turned down the supercharger. Would you recommend about a 400 cc injector ? It does feel like it's not running on all cylinders and the smell of unburnt fuel is quite high.

Ok, it started but is quite lumpy, I'll sort the timing out next. sol2.pclr Log 2020-11-25 6;25;24 pm.llg

error my bad

Theoretically, yes. But I will run though it again.

So after setting the triggers et al I started the engine and it runs very rough and dies after a few seconds. Following the instructions I check the logs for the trigger events and it has only gone up by 1 each time I try to start it. Looking through the logs but I can't seem to find a cause, so where should I be looking ? Any help appreciated.

Thank you so much, I was starting to feel a bit stupid. We will see what fun tomorrow has in store.

Hello and sorry if this has been asked I did search for it but couldn't locate the answer. So I tried to access the triggers to calibrate them and the manual talks of selecting calibrate triggers but I cant find the option anywhere. Also when I attempt to access the online help to find out what triggers are required it doesnt appear to help much so does anyone know what triggers are required for a b16a2 supercharged engine running at about .5 bar ?