Ryley Coker

Here is a better PC log and trigger scope PC Datalog - 2021-03-9 3;56;21 pm.llgx trigger scope 3-9.llgx

MAP is fixed. Had it on the wrong AN Volt. Attached is the new PC Log PC Datalog - 2021-03-9 3;32;05 pm.llgx

Ill recheck the MAP. And try doing some recalibration. And then see. Is there anything else that I might want to change in my Base Start Up Tune? I have the 550cc side feed injectors, EJ22T with DOHC, VF48 Turbo, GReddy Boost controller, FMIC. Not sure if the fueling is right on the tune.

As far as I know nothing changed, I left for dinner and came back and did the PC log. Ill run home on lunch and do another trigger scope and PC log just to be sure. Alright here is a trigger scope, pc log, and some screen snips from my ecu that I just did. PC Datalog - 2021-03-8 12;43;15 pm.llgx TriggerScopeLog 3-8.llgx

As far as I know nothing changed, I left for dinner and came back and did the PC log. Ill run home on lunch and do another trigger scope and PC log just to be sure.

PC Datalog - 2021-02-14 4;11;07 pm.llgx

So when I got the car running the first time, I shut it off and ran an errand, came back and the engine was flooded up the intake runner with fuel. So I had to pull it and do a quick rebuild to get all the fuel out of there. Injectors click when doing the test in the correct cylinder, coil packs test, and fuel pump test was good. TriggerScopeLog 3-7.llgx

Alright, so I have triggers, fuel pressure, rebuilt injectors ( no more leaks), spark (checked), and I have attached my current MAP that I am trying to run. But it will not start. Thoughts? EJ22E Base Startup Map.pclx

IT RUNS! Not very happy BUT it runs!

So here are the updated trigger scopes. I also changed to V1-6. Still no start. Ideas? trigger scope 4.llgx

Well I will dig into finding my wiring issue. And I’ll go change that in the ECU. I’ll reply once I have more info on my wire. Thank you!

Lets try this one. Its not showing stuff right and I followed the directions. I attached a screenshot as well. TriggerScopeLog3.llgx base map.pclx

I do not have a base map that I was given. Could that be my issue? TriggerScopeLog 2-14.llgx

Lets hope I did this right. I have no RPM registering. But the cam and crank sensors have been replaced with the new engine. PC Datalog - 2021-02-14 4;11;07 pm.llgx

So I have the WRX2X link ecu G4X installed. I have gone through the entire setup process. I did the ignition test and injector test as well. Performed the trigger setup. Everything is functioning as it should (I think). But the car just won’t start. Any insight would be great as I’m completely stuck at this point.