Denso

Thanks for your help I got to rpm limit activated 3d and i got 2 limits i did second limit with di2 activated it works very well

Hi thank you so much for your help i did as pictures shows it works fine. I have just a question when i activated gp with settings it is launched control how about if i want it as rpm cut off sound i want to make switch to turn on spark cut off as rpm table not like gp sound

Hello Firstly thank you for your help Finally i get rev limit slowly as i want easy to control it i played with tps and rang limiter now im going to make with switch activation like LC with GP limit if u have any information to add thank alot

i tried with advanced mode still fast i don't no why hysterisis table not added or what way i can control gent slowly than i told u

Today i run link with same wires as i posted before now it is running well rev limit i can change well only one thing spark cut off very fast i want to slow gent

I mean to make switch for LC spark cut off before rpm touch a factory cut off fuel

Hello all I have link g4 atom i want to blug in 1uzfe none vvti i just want change rev limit i want to make it as a packyback i took ignition 1 and 2 wire going to ignitor 1 and 2 also tps singal cam signal crank signal also i have gm map sensor will add i want only work with spark cut off Questions is it right for only spark cut off without add injectors

I have changed my injectors for my m52b30 engine engine running rich even if decreased master fuel and fuel table then i turned lamda off it looks runing little bit rich but still not what i need Questions does deadtime important to change and how to know fuel is enough Also asking about rpm limit And gp limit settings

I have changed my injectors for my m52b30 engine engine running rich even if decreased master fuel and fuel table then i turned lamda off it looks runing little bit rich but still not what i need Questions does deadtime important to change and how to know fuel is enough

No when i raise rpm it goes after TDC abit and engine smoothly

Hi for all I have timing gun trying to setup my timing It gives in timing before tdc runing smooth when i close table it will be advanced after rpm raising i want to know if my settings are ok

Hi adamw I want to know how to calculate master fuel My new enjector 440cc in 3 bar 42Ib Minimum injection time 0.501ms

Sorry for mistake Link g4 atom this is my ecu Also i have problem with fake AFR gauge gives wrong result. Question how to connect AFR to link software

Link g4 atom

Hello for all I have my m52b30 engine Now car running with volvo enjector 6900371 440cc When i search for deadtime I can't matched with link g4 atom column. Link gives different voltage Also in fuel table car runing rich even if i decreased to 11 or 10 rpm will jump to next column. If someone can help me where should i start to make it run not lean not rich