coreyb

yes definitely 12

It has been a while now getting back to this setup.....I also got a 12 teeth bottom wheel and 1 tooth top wheel distributor.....can i just use that instead of removing teeth from the 4 teeth top wheel distributor?

Finally getting back to this project.....customer has a distributor thats 24teeth bottom wheel and 4 teeth top wheel............will this work or do i need to remove teeth from top wheel?

ahhhh....yes now that you mention it that be possible............i will get it check today

Hi Adam attached are picture of connector end of distributor (white wires are now joined and use for ground corresponding to white wire in distributor pic and the black and red correspond with the same colours in the distributor

1 tooth

Attached is trigger scope with triggers set to multi tooth Map is missing tooth trigger which is what gives rpm. Atom 4AGE Base map-v1b.pclx TriggerScopeLog2.llgx

Setting up an ATOM on a toyota 4age 16v engine and i used the recommended trigger setting from LINK help. Engine is stock, ITBs and using distributor with the recommended trigger setting i do not get an rpm but if i use multi tooth/ missing tooth i get rpm. Can i stay with those settings or am i missing something?

Issue resolved It was the trigger setting. Thanks for all the help.

changes were spark edge, re set base and change to multipoint group. NewCrankSensor-v2.pclx PC Datalog -multipoint 2022-11-6 7;03;20 pm.llgx

Got the sync working correctly. But now with the multigroup setting car sounds and act like its not firing on all cylinders. its a 6 cylinder and using a STORM dont know i mentioned this before............a help would be appreciated.

Thanks have the spark edge as falling.....will try it at rising. I assume would have to resync ? Here is scope and latest map NewCrankSensor-v1.pclx TriggerScopeLog_Newsensor.llgx

UPDATE: Still getting large sway on timing when trying to calibrate. We have tried new sensor, made a separate harness for crank sensor still no luck Car has a MSD ignition box could this be an issue and does it need a particular trigger setup? Any help would be appreciated.

Hi. I am about to do my first flex fuel setup on a G4x. Can anyone give info on pin allocation for sensor and also how and where to setup sensor and tables? Regards