1guyver2
-
Posts
3 -
Joined
-
Last visited
1guyver2's Achievements
-
Vaughan reacted to a post in a topic:
Advice on wiring in 3 sensors to xs loom
-
That all worked out perfectly. Got that all setup in the link software no problem. Thanks again
-
Gotcha. Thanks for the info. Sounds like I'm better off using the other plug(on the right) on the ECU for the xs loom. It's a GTR link on an r33 GTST Can I share the same ground for all three?
-
1guyver2 joined the community
-
Looking to wire in the link IAT sensor, an oil temp sensor and oil pressure sensor(3 wires). Advice on where each wire needs to go on the xs loom? I understand the grounds and the iat could go to ground and aux 11 but not sure what to do with the rest. Can I swap over one of the di pins in the link software to use as temp?
