botte_guy

got it all to work out. i selected transmit to generic dash.

I have tried changing PC-Link to Transmit User 1 then check back on the runtime. all is ok. after that i revert to transmit AIM dash and it was all ok but after 5minute or so. then error came back as above. i have attached both my files for you. to see if the setup is correct or not.

Hi Adam. I have attached a picture reference of a wiring diagram that is connected to my can LOW and HI in the Ecu. Which is 14pin connector pin 8&9. Is my pin out correct? I will send u a photo of the runtime tomorrow as the workshop is closed today.

Ok let me try to find it. Thank u so much. In the meantime is my firmware version ok?

Where can I find the errors? Do I have to update my firmware? Or this firmware is ok Oh.. on the Oh.. on the other note.. this can H and L, I just tapped it on the 16pin connector without any resistor. I have a OBD harness already connected to the 16pin connector so I just tap to it. The OBD port remains unplug. Just to tap it on only

Hi there. Im having an issue whereby link won't transmit data to my strada dash. I have attached photos reference of my setup below. From ECU : CAN1/RS232 CAN HI & CAN LOW is connected to the AIM Strada 16PIN Connector PIN 8 & 9. I did not used the original PCB TO CAN wiring loom from Link. I've checked the wiring pinout for link ecu. and connected them to PIN 2 & PIN 3 in the ecu. and also i read somewhere that the firmware has to be update. so will updating my firmware loses my tuning map?

Hi there, i have a mitsubishi evolution 9 with a plug-in Links G4. I would like to set up a rev limiter/speed limiter via toggle switch on my links. would appreciate if anyone could shed some light on how can i go around this?