eldrblack

I ended up buying gt 101 style sensors, worked great for me with oem abs rings

Bro I made 520 whp and 436 of torque today. If That's not a fix ahaahah I don't know what is ahaahha

I will show you guys how i fix this issue. My main problem was running out of cell values in the main fuel table, i was going into 150 and the car was lean. I was tunning on e100. the simple fix was to move back to traditional mode (fuel equation) and adjust the Master fuel trim, i put 30 % and the values of the table were multiplied,and now i have enough resolution to finish the job.

Hello guys i will like to read your opinions, i went to tune my car today. Gave me 354 whp with 314 tq at 8psi. But my data shows my close loop lambda correction at 40% i had to increase the correction. My ve table is maxed out 150 in some cells, but i continue to have lean conditions. i hope someone can point me in the right direction. log se va pobre.llgx mapa se va pobre.pclx

ok man, i will take it to the street and drive like californian at the takeovers ahahaa thanks

Hello mi gente, im trying to configure traction control in my civic eg with link g4x plugin. Im using 97 01 Honda crv front sensor. I get resistance when i measured the two wires (0.959) and also voltage while rotating the tires (Mv) but i cant get a signal to the Digital input. Im using this kind of sensor, i will like to know if this sensor will work, or should i move to gt101 style sensor. thanks

here is the right one. mapa civicdbw.pclx Hey guys my wife came to the car touched the dang tb and it worked out, i think was some ground issues or something, thanks to all

Here is my map. mapa civic.pclx

Hello good afternoon. I had my computer in service for the last weeks, i got it yesterday. I tried to configure my DBW (again) but no im getting error 15: H bridge is not configured properly. I have aux9/10 and aux 16 as relay. Any ideas? thanks

That was fast. Thanks man.

Hello good morning/night. I will like to know if there is a way to know the status of an ECU sent to NZ for repair. If anybody knows hit me up pls. Thanks have a nice day.

oh man i didnt know, i thought he work pro bono here aahahhahah

Thanks man. I think link should hire you. You helped a lot of people here in the forum.

HEllo guys, my name is robert i am from mexico. i have my 95 civic with k24a2, i recently purchased link g4x plug in, everything excellent so far. I have this error while configuring DBW. BOSCH 74 mm tb and jetta mk4 pedal. i can calibrate pedal, and tb, but only at 150 hz, i have put the oem pid but doesnt calibrate. I have my log, my aux 9-10 supply volt is low, goes to 4 volt while calibrating the tb, but my battery voltage reads 11.10 volts. any ideas? Thanks in advance. bajo voltage.llgx