Trond Retterholt

Simon, I ended up with value 37 in boost table. I would like to switch between 1 bar and 0.7 by switching the solenoid off. I assume I just cut 12 v power to solenoid by a dip switch. I have the solenoid connectet to aux output 4, which is port 19 on G2 unit (orange/yellow cable). Is this the cable that controls the boost solenod and the cable I connect the dip switch too ?

Hi, Just dyno'd the engine and found that I was boosting on 1.2 bar. I would like to install a 0,7 bar wastegate spring and adjust boost electronic by ecu and the installed mac solenoid. How do I build the boost table to make this work? I'm thinking that I will activate boost mode to "open loop" and Load index at "Boost adjust" Then I'm not sure how to set table to reach 1 bar. Is is possible to have a switch inside the car that activated this table/solenoid to be in use and deactivate when want to run 0,7 bar all over?