Hi,
Just dyno'd the engine and found that I was boosting on 1.2 bar.
I would like to install a 0,7 bar wastegate spring and adjust boost electronic by ecu and the installed mac solenoid.
How do I build the boost table to make this work?
I'm thinking that I will activate boost mode to "open loop" and Load index at "Boost adjust"
Then I'm not sure how to set table to reach 1 bar.
Is is possible to have a switch inside the car that activated this table/solenoid to be in use and deactivate when want to run 0,7 bar all over?