TyroneTurbos

Useful guide I found while searching for cop coil pack with built in ignitors http://www.sq-engineering.com/tech-articles/coilpack-info-guide

Have a read here prity good article http://www.sq-engineering.com/tech-articles/coilpack-info-guide

COP are Blueprint ADH21478 On the cam pick up do I just disgaurd the wiring for crank pick up ? Ross

Hi have a forged 4efte on the bench just in process of fitting, plan on running cop set up, not quite sure yet if I will require an igniter for cop or if 3 wire coils have built in igniter, 4e has cam pick up so good for fully seq, but will I require a crank input or can this be configured via the cam pick up in ecu settings, If a crank pick up inst required do I dismiss the wiring or wire it to cam also and configure in ecu to determine crank position this is the only thing I'm a bit sketchy on with the entire job so little light on it now will save allot of head scratching later. Ross

Building a 4efte also and running Link Monsoon have most things figured just the ignition system, can seem to find which type of ignigtor i need (if any) to run coil on plug and some basic wiring for it, also trigger input for the ecu as you know the 4efte uses cam only, do I need to install crank trigger or just use the cam trigger and configure it via the ecu ? p.s using the the A loom 2.5meter engine isnt in a glanza Any advice taken on board thanks. Ross Also seen a post where there are certain cop coils that have built in igniters 3pin so I can wire these 12v Grnd Parallel then 4 drivers from ecu ? for seq ignition