[PC-LINK does not communicate when AIM Dash MXS Strada and LINKECU are connected.]

まず、パソコンを「USB⇒」に接続しました。
AIMMXLを「CAN/RS232」に接続しました。
その場合、PC〜LINKECU〜AIMは同時に接続できませんでした。

AIMMXLを「CAN/RS232」に接続しました。
PCを「CAN2/OBD」に接続しましたが、通信できませんでした。

正しく接続する方法を教えてください。

 

 

[PC-LINK does not communicate when AIM Dash MXS Strada and LINKECU are connected.]

Hello everyone.
I am using AIM MXS Strada for the Nissan GTR LINK plug-in.
In this case, PC - LINK can not communicate.
If you disconnect the CAN connector of MXS Strada, PC - LINK can communicate.
This is inconvenient.
Is there a solution?

[I want a HONDA B16 TURBO MONSOON BASE MAP]

Thank you very much.
 

[I want a HONDA B16 TURBO MONSOON BASE MAP]

Hello everyone.
It is Honda Civic B16 turbo.
LINK G4 + MONSOON is used.
I need a base map.
Ignition method remains as it is. (Distributor ignition method)
I am waiting for good news.
Thank you very much.

[Key ON tachometer sweep]

 Thank you for your explanations.

[Key ON tachometer sweep]

Is there no way?

[350Z G4+Plugin Closed Loop Lambda]

That was really helpful. Thanks a lot.

[Key ON tachometer sweep]

Hello everyone.

Key ON tachometer sweep method.
I do not know how to do it.
Is the current setting incorrect?

It is 350Z G4 + plug-in.

Best regards

 

[350Z G4+Plugin Closed Loop Lambda]

350 Z after September 2004 will not function.

My 350Z in 2003.

Currently Stoich Mode (Narrow Band) is working at stock O2 sensors.

[350Z G4+Plugin Closed Loop Lambda]

Hello everyone.

350 Z Stoich Mode (Narrow Band) Closed Loop Lambda reflects which signal of AN Volt 10 - O2 Sig RF or AN Volt 11 - O2 Sig LF?
Right side? Left side ? Or both?
The set values of AN Volt 10 - O2 Sig RF and AN Volt 11 - O2 Sig LF remain the default of the 350 Z base map.

Best regards

 

 

[350z traction control]

I thought by looking at the wiring diagram, but I could not understand it.
Please tell me in detail.
Please also tell me about software settings.
I’m at a loss of what to do.

[Expansion loom]

I drilled a hole in the side.
The front becomes an obstacle to opening and closing the case.

[350z traction control]

I am very grateful to you.
I'll give it a try.

[350z traction control]

Please tell me the way of terminal and connection.

[350z traction control]

I inserted a 350 Z plug-in.
SLIP and VDC light up.
This is a non-functional state.
VDC ON / OFF switch does not respond.
Please tell me the method of recovery.