Hello,
I recently wired and installed an oil pressure and oil temp sensor to my link g4+ TALT+ ecu. Specifically this oil temp sensor - https://www.nzefi.com/product/bosch-engine-oil-temperature-sensor/ . Just a standard Bosch ev1 type. Anyhow, I setup the calibration table (cal table 1) per the instructions and wired one of the wires to the AN temp 3 ecu pin and the other the sensor ground. However, I am not getting any changes in value through pclink while the engine is running. The oil pressure sensor works perfecting fine. Is there something I am missing here? Any thoughts on this would be appreciated. I have attached a copy of the pclr file that I am currently using if that helps.
Thanks,
Terrance
+5 and new Sensors.pclr