Ke13b Posted April 18, 2020 Report Share Posted April 18, 2020 Hi Iv just installed a link atomg4x to run a 13b. I have a leading direct ignition (smart coil for each plug). I have run an ignition test and all fine in that department. I have stabbed cas and when cranking my trigger1 and 2 are giving feed back and rpm. When I crank it over (cranking rpm220rpm)with cas in I cant get any spark, And the ignition state says inactive. If I pull the cas out and spin by hand (350 and up rpm) the ignition become active and sparks. I have tested the coil voltage while cranking is dropping to 10.8v(which I thought would be sufficient?). My ignition map gos as low as 0rpm. Is there something I am missing here? Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 18, 2020 Report Share Posted April 18, 2020 First, make sure you are on the latest firmware, there was a problem with the reluctor settings in an early release. Next can you do a triggerscope of it cranking and attach that and your tune here. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.