No RPM signal using FFE trigger!

[13bees]

I finally finished the loom and wired everything up, but now that I am trying to set base timing, I found I was not getting any spark!

I first thought it was my timing light but changed that and nothing! I then noticed that there was no RPM signal being generated, hence no spark!

I am running an FFE trigger which was working on my last ECU (Megasquirt) so have reason to believe it should be fine, I have checked continuity of the wiring, Pin 7 (Green - white at end of harness) goes to white on Hall sensor, Pin 8 (Black) goes to black on Hall sensor, 12V on the red wire, even when cranking.

Settings on trigger (tig 1) are missing tooth, 36-1, Pull up was on, not sure if this should be on or off for FFE trigger?

Trig 2 sync is off.

Moonsoon doesn't support trigger scope so I can't see anything there.

When I run LOG, nothing on engine speed or trig 1 signal.

Anyone with any suggestions what to check next?

[13bees]

Problem solved, Hall sensor was wired incorrectly!