artvk Posted June 12, 2020 Report Share Posted June 12, 2020 Hi, Hi I working on the dash using Plug N Play cable with Link G4+ Fury. All data needed have shown except speed. When I try to select Speed Input in Speed setup the dashdesign software shown error and then shutdown. Anyone have suggestion to bring speed data into the dash ? Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 12, 2020 Report Share Posted June 12, 2020 There is no "Speed Input" channel in the Link stream. Use whichever one of the 4 wheelspeeds you have set up in the ecu. Quote Link to comment Share on other sites More sharing options...
artvk Posted June 12, 2020 Author Report Share Posted June 12, 2020 Hi Adam, Thank you for quick reply. Got it now. Everything work fine. Speed showing on the dash is slightly different from on OEM speedo. for instance , speed on dash is 100km/h and OEM speedo is 120km/h when vehicle cruising more than 100km/h/. But less different when low vehicle speed. Do I need to calibrate in Link Fury or better on AEM DashDesign ? Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 12, 2020 Report Share Posted June 12, 2020 12 hours ago, artvk said: Do I need to calibrate in Link Fury or better on AEM DashDesign ? You need to adjust the calibration factor in the ECU digital input settings so that the ECU shows the correct speed. The dash will then match. Quote Link to comment Share on other sites More sharing options...
artvk Posted June 13, 2020 Author Report Share Posted June 13, 2020 ah ok. Thanks again. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.