benjaminogambino Posted August 7, 2020 Report Share Posted August 7, 2020 Just finished putting this all back together. Could really use a hand getting er running. Everything seems to "test" fine, but it won't turn over? What am i missing? Thanks! 08072020 First Start.pclx trigger scope 08072020.llgx Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 7, 2020 Report Share Posted August 7, 2020 Did you check base timing? Pretty odd to have the offset at 0, I think normally around -85 on an RB. Also, your old fuel table is not suitable as a VE table in modelled mode. Highlight the whole table and multiply by 2 will be closer. Also in modelled mode you should turn of the IAT trim table and zero out warm-up enrichment. Also, at the time you saved that map, your MAP sensor was reading 164Kpa, which doesnt seem right, and you have a 100% fuel cut active for the boost cut. Quote Link to comment Share on other sites More sharing options...
benjaminogambino Posted August 7, 2020 Author Report Share Posted August 7, 2020 Like this? Doubled the fuel table and zero'd warm up enrichment. Probably forgot to calibrate the MAP. now it's at 1bar. 08072020 First Start.pclx oh and I have no idea what/where boost cut is... Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 7, 2020 Report Share Posted August 7, 2020 12 minutes ago, benjaminogambino said: Like this? No, negative 85. But rather than just put random numbers in there, you should put a timing light on it and adjust the offset until the timing light matches whatever you have in the "lock timing to" box. Quote Link to comment Share on other sites More sharing options...
benjaminogambino Posted August 7, 2020 Author Report Share Posted August 7, 2020 Please excuse my ignorance. Doesn't a timing light work only once the car is running? Or will it work as I'm cranking it with the starter? Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 7, 2020 Report Share Posted August 7, 2020 It will work when cranking Quote Link to comment Share on other sites More sharing options...
benjaminogambino Posted August 8, 2020 Author Report Share Posted August 8, 2020 ok so i swear i did it the right way, but it happened to be, right at -85. Thank you! I can get it started with a bit of throttle, but can't keep it running without... I know the instruction book says to use the master fuel tab to adjust once it's running, but adjust how? 08082020 first start.pclx Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 8, 2020 Report Share Posted August 8, 2020 1 hour ago, benjaminogambino said: I know the instruction book says to use the master fuel tab to adjust once it's running, but adjust how? You dont have a master fuel setting in modeled mode. The equivalent in modeled mode would be to highlight the whole fuel table (click the grey cell at top left corner), then adjust the whole table up or down (shift + Page up/Pg dwn) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.