dan wilson Posted September 12, 2020 Report Share Posted September 12, 2020 hi I just updated my firmware to g4 Just wondering about the pinout change Do the pin outs change or just the name of them in the software Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 12, 2020 Report Share Posted September 12, 2020 Just the name of the analog inputs in the software since the G3 had the first three that were labelled "load inputs" . So, G3 pin originally labelled "Load 1" is now AN Volt 1 in G4 software. G3 pin Load 2 is AN Volt 2. G3 pin Load 3 is AN Volt 3. G3 pin AN Volt 1 is now AN Volt 4 in the G4 software. Quote Link to comment Share on other sites More sharing options...
dan wilson Posted September 13, 2020 Author Report Share Posted September 13, 2020 Ok weird all my an temps all falt to 5v Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 13, 2020 Report Share Posted September 13, 2020 Have you set the fault settings correctly? Usually low of 0.05v and high of 4.95v Quote Link to comment Share on other sites More sharing options...
dan wilson Posted September 13, 2020 Author Report Share Posted September 13, 2020 Hi i just figured that out. I'm new to the g4 software Now I just got to figure out how to input my map Might just send it too link hq Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.