Kassan1973 Posted September 26, 2020 Report Share Posted September 26, 2020 Hi All i have the following information for a BTR trans temp sender and want to know the best way to put it in a calibration table, doing the ohms and output is ok but i only have limited figures and the calibration table has quite a number of columns more than i need and i can figure out how to delete columns. Im just going to use the middle ground of each figure as this should be close enough for my use Would this work think its correct i just interpolated between all the known figures sorry for the pic Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 27, 2020 Report Share Posted September 27, 2020 The 5 calibration points you quote match our "Bosch Std NTC" calibration - so you dont even need a cal table. Quote Link to comment Share on other sites More sharing options...
Kassan1973 Posted September 28, 2020 Author Report Share Posted September 28, 2020 Fantastic , lucky i guess that it matches a ford BTR trans temp sender. Thankyou Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.