Pete_89t2 Posted February 6, 2021 Report Share Posted February 6, 2021 I'm running a G4+ Fury with a modified single turbo FD RX7. Since I added a couple of Bosch knock sensors to the motor (1 on each rotor housing in the OEM location, using the Bosch broadband "donut" style sensors), I was wondering how I would go about testing/characterizing the sensor's outputs, but not necessarily have them do anything with regards to actually control knock at this point? (i.e., take action to retard timing, etc.). Will setting all the values in the Knock Target Table to maximum of 1000 do the trick? That way I can log the outputs of my knock sensors without them intervening with anything? Thanks! Quote Link to comment Share on other sites More sharing options...
Scott33 Posted February 6, 2021 Report Share Posted February 6, 2021 You can set Knock Control->Knock Setup->Ign Retard Limit to 0. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.