Guest |427| Posted June 4, 2012 Report Share Posted June 4, 2012 I have some problems setting up my Nos controll. There is no "nitrous" option for the Aux outputs so I guess I'll need to stick with GP output. Guess i'm gonna be using the virtual AUX options to do this: I would the nos to be actived by a switch (di#4) I will run a dry system and add fuel via the 4d fuel table. Maybe i'll pull some timing via the 4d ignition table I got full boost @ 6000rpm (revlimit 9000) so i would like the nos to be used betwee 5500-8900rpm I don't won't the nos to be activated while using launch controll, gearcut or while being at the revlimit I also only want it to be activated when TP above 90% and MAP above 140kpa How will i setup this the best? Quote Link to comment Share on other sites More sharing options...
Simon Posted June 7, 2012 Report Share Posted June 7, 2012 You will need to use a GP output. Two conditions will be the RPM low and high. The third will be a virtual aux (giving three more conditions) These could be set as DI4, Throttle position and "Engine Limits" There will be a bit of thinking involved about making sure that all the conditions and polarities are correct. The engine limits flags should cover gear cut, launch control and rev limit. If you set this all up to how you would like I can run on the bench to test it all if you email the file. Quote Link to comment Share on other sites More sharing options...
Guest |427| Posted June 10, 2012 Report Share Posted June 10, 2012 yea , that would be great, i'll setup it using 2 virtual tables which email shall i send it to? Quote Link to comment Share on other sites More sharing options...
Simon Posted June 10, 2012 Report Share Posted June 10, 2012 Send to [email protected] Quote Link to comment Share on other sites More sharing options...
youask Posted June 11, 2012 Report Share Posted June 11, 2012 I tried [email protected] instead Quote Link to comment Share on other sites More sharing options...
Simon Posted June 13, 2012 Report Share Posted June 13, 2012 woops you were correct I missed the critical - Quote Link to comment Share on other sites More sharing options...
youask Posted June 13, 2012 Report Share Posted June 13, 2012 send email again:) Quote Link to comment Share on other sites More sharing options...
Simon Posted June 13, 2012 Report Share Posted June 13, 2012 From your suggestion of " Activation switch for NoS: Di-4 NoS Solendoid hooked up via Relay on Aux o/p 6 Conditions for nos Virtual Aux#1 must be on (RPM 5500-8700) Gear 2 or above. Virtual Aux#2 must be off (virt-aux#2 is only on when Engine limits is 1 (on=gearcut, launch or revlimit) Virtual Aux#3 must be on Tp is above 90% " Testing this on the bench it all works spot on. Some clever thinking on your part there. boost is above 0.3bar Di#4 switch is on Quote Link to comment Share on other sites More sharing options...
youask Posted June 19, 2012 Report Share Posted June 19, 2012 great! That'll be the setup then:) thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.