Jefferson.C Posted August 30, 2021 Report Share Posted August 30, 2021 I have installed two 7bar WHP (ECU Master) pressure sensors for fuel and back pressure. Gauge pressure 0-100psi. Would the 7bar calibration be correct for these sensors or should I use a Cal 4-6? Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 30, 2021 Report Share Posted August 30, 2021 You will have to use a custom cal for that, the 7 Bar option is for the Link MAP sensors. I would also suspect they are probably 100psi rather than 700kpa so I would do the cal like so: Quote Link to comment Share on other sites More sharing options...
Jefferson.C Posted August 30, 2021 Author Report Share Posted August 30, 2021 Great, thanks Adam. Last question regarding the AN V error. If I use the 0.5v & 4.50v with the error value of 0 kPa I get a fault code. Is it acceptable to use 0v & 5v here to avoid the error fault? Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 30, 2021 Report Share Posted August 30, 2021 Those values I show above are the calibration values. The error values are done separately on the analog input settings - Error Low and Error High. Usually the error low/high would be 0.05 & 4.95 Jefferson.C 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.