lc111 Posted March 12, 2022 Report Share Posted March 12, 2022 Hi all, wired in my mxg dash today but can't get any info to come up from the ecu via can. It's set up on can 2 with my aem wideband and I'm getting a feed from the wide band so know its working. I've followed the guide for can setup but still no info being sent to it. Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 12, 2022 Report Share Posted March 12, 2022 You have the bitrate set to 500K. The Link branded MXG is 1Mbit by default, make sure you have chosen the 500K ecu stream in the dash config. Also, on your CAN setup channel 2, the ID format should be set to normal, not extended. Quote Link to comment Share on other sites More sharing options...
lc111 Posted March 14, 2022 Author Report Share Posted March 14, 2022 thanks for your help adam, heres my tune file and dash setup. 120 ohm resistor is turnt off as i have one at the end of the line already from when i had only the wideband attached. dash fit.pclr MXG 1.2 Strada rx7 dash.zconfig Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 14, 2022 Report Share Posted March 14, 2022 I dont see anything wrong. Can you import and load this config into the dash as a test. I have seen the configs get messed up before. MXG 1.2 Strada Test.zconfig Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.