Flat4supersport Posted March 30, 2022 Report Share Posted March 30, 2022 Is this possible? I was hoping to have both read lambda values but since activating the CAN Lambda the Lambda 1 parameter is now reading the CAN Lambda not internal Lambda. Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 30, 2022 Report Share Posted March 30, 2022 All CAN lambda's are programmed as Lambda 1 by default. To change this, go to >ECU Controls>CAN set up>CAN devices. Select the correct CAN port/module that the lambda is wired to, then hit find devices. Once found change the parameter to Lambda 2 and click send. You will then need to power cycle the lambda and it will show as Lambda 2 next power up. Quote Link to comment Share on other sites More sharing options...
Flat4supersport Posted March 30, 2022 Author Report Share Posted March 30, 2022 Awesome, thanks Adam. :-) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.