Mspec Posted May 1, 2022 Report Share Posted May 1, 2022 I have a g4+ Storm (blue) with CAN lambda module, the lambda reading works fine on my laptop in the ecu software but I cant get it to work on the race technology DASH2 pro. All other information is transmitting fine to the dash just not the lambda. It is more than likely the setup in the dash2 pro but not sure where I’m going wrong? Any thoughts thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 1, 2022 Report Share Posted May 1, 2022 Can you attach your dash config and ecu map. Mspec 1 Quote Link to comment Share on other sites More sharing options...
Mspec Posted May 13, 2022 Author Report Share Posted May 13, 2022 Hi yes i can, thanks for the reply. will post below I have tried so many options, just missing the right one - currently set up as Lambda 2 but not working. Hope you can shed some light on it cheers Mike. MspecGT2R13052022-CANLAMBDA-Check.pclr DASH2PRO-MspecGT2R13052022-CANLAMBDA-check.CMG Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 13, 2022 Report Share Posted May 13, 2022 Its not enabled as a CAN input in that config. Have you ever had this channel enabled? Quote Link to comment Share on other sites More sharing options...
Mspec Posted May 13, 2022 Author Report Share Posted May 13, 2022 Yes I have tried that one but didn’t work - however that doesn’t rule out I could have had the setting wrong Lambda1 on the ecu doesn’t give a reading - I have to use lambda avg. to get a reading in pclink software. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.