JakeRX4 Posted July 24, 2022 Report Share Posted July 24, 2022 I was wondering if anyone on here could give me a little bit of assistance getting my FuryX to to to my PMU16 PDM. Ive been going back and forth over it all day I I cannot for the life of me work out what I'm cocking up and would like someone to have a bit of a look over for me. I'll attach both configs below. The CAN line also has a CanGauge on it which is working as I would expect. Thanks all. RX4_PMU.pmu RX4_Setup_July_2022.pclx Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 24, 2022 Report Share Posted July 24, 2022 Got job on your setup, it looks good to me and I cant see any mistakes in terms of comms, it should work as far as I can see. I suspect Starter control might not act how you want - it might get "stuck on" since status "engine running" is decimal 2 which may keep the starter output channel true , so be careful with that once you get comms, but otherwise all looks ok. You might want to change that starter output to a formula with c_Starter value = 1. If you check the live capture box are you seeing any data in the area below? How about in the Light client, do you see 0x44C data in there? Quote Link to comment Share on other sites More sharing options...
JakeRX4 Posted July 25, 2022 Author Report Share Posted July 25, 2022 Thanks for getting back to me Adam, im just back down and plugged in now, im getting no live data through in the pmu software, or in lightclient. But as I said, the CanGauge is on the same line and is working correctly. Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 25, 2022 Report Share Posted July 25, 2022 If the gauge shows there is data on the bus there must be a disconnection somewhere. Connect the USB to CAN device in place of the gauge to confirm data is there. If so then you can start investigating where it is lost. Quote Link to comment Share on other sites More sharing options...
JakeRX4 Posted July 25, 2022 Author Report Share Posted July 25, 2022 Right Adam, hows this for a great chat. pmu pin for can 2 low was obviously incorrectly stamped in the factory, completely open tunnel. have replaced the pin and now have data! Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 25, 2022 Report Share Posted July 25, 2022 I have had one before where the terminal was crimped on to a wire that hadnt been stripped first… Quote Link to comment Share on other sites More sharing options...
JakeRX4 Posted July 25, 2022 Author Report Share Posted July 25, 2022 Thanks for your assistance, sometimes it helps having a different perspective on an issue. Apart from adjusting a couple of offsets, all data came through as expected. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.